[. . . ] Please take a few minutes to study this manual so that you can take advantage of the benefits of your new machine. The manufacturer will not be held liable for any damages resulting from EN incorrect or improper installation. [. . . ] The minimum safety distance between the cooker top and the extractor hood is 650 mm. Check that the mains voltage corresponds to that indicated on the rating plate fixed to the inside of the hood. If the extractor is used in conjunction with non-electrical appliances (e. Gas burning appliances), a sufficient degree of aeration must be guaranteed in the room in order to prevent the backflow of exhaust gas. The kitchen must have an opening communicating directly with the open air in order to guarantee the entry of clean air. use · The extractor hood has been designed exclusively for domestic use to eliminate kitchen smells. Never use the hood for purposes other than for which it has ben designed. The hood can be installed either directly on the bottom surface of the wall units (min. Cut a fitted opening in the bottom surface of the wall unit, as shown. When installing the ducting version, connect the hood to the chimney using either a flexible or rigid pipe ø 150 or 125 mm, the choice of which is left to EN the installer. Connect the hood to the mains through a two-pole switch having a contact gap of at least 3 mm. The filters must be cleaned every 2 months of operation, or more frequently for particularly heavy usage, and can be washed in a dishwasher. Remove the filters one at a time holding them up with one hand and pulling the handle downwards with the other hand at the same time. When refitting the filters, make sure that the handle is visible on the outside. [. . . ] Remove the filters one at a time holding them up with one hand and pulling the handle downwards with the other hand at the same time. When refitting the filters, make sure that the handle is visible on the outside. [. . . ]